Installation manual

Arecont Vision MegaBall™ Installation Manual
4 | Page
5. Using the provided Security L-key (Image
1F), loosen the three (3) screws securing the
dome cover (Image 3). Remove the vandal
resistant dome cover. NOTE: Do not remove
the screws from the dome cover.
Image 3
6. Loosen the three (3) machine screws (Image
4) and remove the in-ceiling mount camera
from the surface mount housing. (Image 4)
Image 4
7. Using the mounting template, cut a hole in the
surface for mounting.
In-ceiling Mount Installation (Optional)
8. Insert the in-ceiling mount camera into the
hole.
9. Tighten the “lever screws” until the flush
mount is snug, as shown in Image 5. The
“Support Arm” will ride down the screw to
compress the mounting surface. NOTE: Do
not over-torque the lever screws.
Image 5
10. Align the holes in the surface mount with the
prepared holes on the mounting surface with
the wood screws or any optional hardware
suitable for the mounting surface.
Surface mount installation
11. Attach the in-ceiling camera to the surface
mount.
Screws
Lever
Screw
Support
Arm