Installation Manual

Microdome Duo® Installation Manual
Page | 30 [e-mail]
+1.818.937.0700 | 877.CAMERA.8 | www.arecontvision.com | [e-mail]
Reset to Factory Default
Press and hold the Reset Button, release it after 10 seconds. See picture below for approximate switch
position on board. The camera has been reset to the factory default.
If the camera is not connected to DHCP server, the camera will use Link-local address.
The Reset to Factory Default can be done via camera Web interface or AV IP Utility.
NOTE: Additional information regarding the Arecont Vision® web interface can be found separately in the AV
IP Utility Web Browser Manual via the Arecont Wision website http://www.arecontvision.com
Approx. Switch Position (board top view)