Installation Manual

! ! Installation Manual
!
Page | 27 [e-mail]
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaDome
®
G3 RS
Auxiliary Power
If the camera is powered by a separate outside DC or AC power source, run the supplied power
cable through the access hole on the camera housing and connect the power cable to the 2-
position connector on the main camera board. The approximate location of the 2-position
connector is circled below.!!
!
!
NOTE: Cameras using auxiliary power with 802.1x enabled may need to manually power cycle the
camera to reconnect to the network.
!
CAUTION! Make the connections inside a watertight compartment. Isolate unused power
wires individually.
After connections are made, ensure that the watertight compartment is tightly closed and
cables and conduits are properly sealed to prevent ingress of water.
NOTE:&A&yellow&LED&on&the&rear&of&the&camera&illuminates&after&a&few&second s.&&
• The flashing yellow LED indicates that a link to your computer has been established.
• A green LED will blink when the camera has been accessed.
LED
Status
Description
Yellow
Flashing
Link has been established.
Solid
Normal Operation.
Green
Flashing
Camera has been accessed. Normal operation.
Solid
N/A
None
None
No Connection.