Installation Manual

Installation Manual
Page | 28 [e-mail]
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaDome
®
G3
Camera Power Up
This product should be installed by a qualified service technician in accordance with the
National Electrical Code (NEC 800 CEC Section 60) or applicable local code.
1. Connect the camera to a PoE port on 100Mbps network PoE switch using an Ethernet cable as
shown in the image below.
!
Reference #
Description
1
PoE Connector
2. If the camera is powered by an outside power supply, 12-48 VDC or 24VAC, connect the power
cable.
3. Connect the PoE switch to your computer’s network port using an Ethernet cable.
Auxiliary Power
If the camera is powered by a separate outside DC or AC power source, run the supplied power
cable through the access hole on the camera housing and connect the power cable to the 2-
position connector on the main camera board. The approximate location of the 2-position
connector is circled below.!!