Installation Manual

Arecont Vision MicroDome™ Installation Manual
Page | 6 [e-mail]
Focusing the Camera
1. Open a live view of the camera from your web browser or the AV Software provided (AV100 or AV200).
2. Loosen the lens lock screw using a phillips head screwdriver (if necessary). Only do so if lens seems very
tight when turning. Lock screw should
be tightened enough to provide some
friction against the lens to avoid
focusing problems.
3. Manually rotate the lens to adjust the
focus until the desired image is
obtained.
4. For some lenses a focus shift will occur once the bubble is in place. Hold the bubble up to the lens when
focusing to account for the focus shift or see the “Focusing Alternate Lenses” section below for further
instruction.
5. Retighten the lock screw if necessary.
6. Install the Dome Cover by aligning the captive fasteners with the mating threaded holes on the camera
housing.
7. When mounting the Dome Cover to the Camera Housing ensure that the gasket is properly seating and
not folded. Failure to do so may result in water and dust
ingress.
8. When mounting the Dome Cover to the Camera Housing do
not over torque the three captive fasteners as this will cause
the threads to strip. Only hand tighten these screws.
Tech
Tip
Tech
Tip