Installation Manual

Installation Manual
Page | 33 [e-mail]
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaDome
®
G3
SD Card Tab
Menu
Feature
Description
View SD Recording
ROI
Allows the user to drag the box to the area where need
to be recorded.
Continuous Recording
Allows the user to continuously record without restriction.
Default is unchecked box.
Stop Continuous
Recording AND Enable
Event-triggered
Recording
Allows the user to enable events recording when network
failure, motion alarm, or an I/O alarm is triggered. Default
is unchecked box.
NOTE: if the continuous recording is disabled and no
event recording is enabled, the SD card will not initiate
recording.
Network Failure
Allows the SD Card to record video only in the event that
the network fails.
Motion Alarm
Allows the SD Card to record video only in the event that
motion is detected.
I/O Alarm
Allows the SD Card to record video only in the event that
an I/O alarm is triggered.
Recording Framerate
Allows setting a frame rate output limit for the H.264 video
stream. Reducing the frame rate output is another way to
control the bandwidth used for the H.264 video streaming
from the camera trade off is the obvious reduction of
frame rate output at the camera.
SD Record Video Type
Provides the ability to set the record video type. Options
are JPEG and H.264.
SD Card Image
Resolution
Provides the ability to set the resolution. Options are Full,
Half, or Scaled. Half is the default.
Playback
Allows the user to choose the specific time of video to
playback.
Start
Shows the beginning time frame of the video being
recorded. No default.
End
Shows the ending time frame of the video being recorded.
No default.
Delete All Records
Allows the user to delete any previously recorded video on
the SD card.