Installation Manual

Installation Manual
Page | 15 [e-mail]
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaDome
®
G3
9. Attach the Dome Cover to the MegaDome
®
G3 camera and fasten securely four captive screws
as shown in Figure 6.
!
Figure 6
NOTE: When attaching the Dome Cover, make sure the IR foam on the lens not block the field
of view.
10. To configure the camera, reference the camera discovery, set-up and configuration section.
!
CAUTION! The captive screws must be used to properly secure the dome cover and
camera housing. Failure to use the captive fastener may result in serious injury. When
mounting the dome cover to the camera housing, ensure that the gasket is properly seated
and not folded. Failure to do so may result in water and dust ingress. Water damage from
improper installation is not covered by the warranty!