Installation Manual

Arecont Vision MegaVideo

Compact Camera Series Installation Manual

MegaVideo

Compact Camera I/O Cable Connection

Required Tools:

 Flathead screwdriver

Image 14

1. To use the I/O ports of the MegaVideo

Compact Camera, insert the connector into the

camera and locate the “I/O” ports as shown in

Image 14. NOTE: There are six connectors

that look identical, be sure to use the correct

I/O ports as shown in Image 15.

Image 15

Electrical Characteristics: Min Max

Input voltage (V) ON 2.9 6.3

(measured between + and –

terminals)

OFF 0 1.3

Output current (mA)

ON - 50

(measured between + and – terminals)

Applied Voltage Rage: 0 - 80V

OFF - 0.1

Table 1

NOTE: Both the input and the output are electrically

isolated from the rest of the camera’s electrical

circuitry via general-purpose photo couplers. The

input is additionally protected with a serial 250 Ohm

resistor and a debouncing circuit. Duration of any

input signal should be at least 5ms to comply with

the requirements of the debouncing circuit.

ut

Out

ut