User manual

ARECONT VISION USER MANUAL 92

Arecont Vision 425 E Colorado St, 7

Floor Glendale, CA 91205 8/1/2012

www.arecontvision.com

Chapter V - Regulatory Compliance

FCC Compliance Statement

All Arecont Vision cameras have been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference, in which case the user will be required to correct the

interference at his/her own expense.

Modifications not expressly approved by the manufacturer could void the user's authority to operate the

equipment under FCC rules.

1. It is suggested that the user use shielded CAT6 cables to comply with FCC rules.

2. It is suggested that the user use power-over-Ethernet supply

3. To comply with FCC rules when using auto-iris with AV1300, AV2100 and AV3100 it is also

suggested using a ferrite common mode choke Fair-Rite # 0444164281 with 1 ½ turns place on the

auto-iris lens cable three centimeters from the lens.

Terms and Conditions of Sale

1. Terms and Conditions. This sale is subject to the terms and conditions set forth below, which

supersede any and all terms and conditions set forth in any documents issued by Purchaser,

including Purchaser’s purchase order. ANY ADDITIONAL, DIFFERENT OR CONFLICTING TERMS

AND CONDITIONS HEREBY ARE OBJECTED TO BY ARECONT VISION, LLC (“AV”), AND SHALL

BE OF NO FORCE AND EFFECT. No waiver or amendment of these terms and conditions shall be

binding on AV unless made in writing expressly stating that it is such a waiver or amendment and

signed by AV.

2. Limited Warranty. AV warrants to Purchaser (and only Purchaser) (the “Limited Warranty”), that: (a)

each Product shall be free from material defects in material and workmanship for a period of twelve