Installation Manual

ArecontVisionMicroDome™InstallationManual
Page | 6 [e-mail]
FocusingtheCamera

1. OpenaliveviewofthecamerafromyourwebbrowserortheAVSoftwareprovided(AV100orAV200).
2. Loosenthelenslockscrewusing aphillipsheadscrewdriver(ifnecessary).Onlydosoiflensseemsvery
tightwhenturning.Lockscrewshouldbe
tightenedenoughto
providesomefriction
againstthelenstoavoidfocusingproblems.
3. Manuallyrotatethelenstoadjustthefocus
untilthedesiredimageisobtained.
4. Forsomelensesafocusshiftwilloccuronce
thebubbleisinplace.Holdthebubbleuptothelenswhenfocusingtoaccou nt
forthefocusshiftorsee
the“FocusingAlternateLenses”sectionbelowforfurtherinstruction.
5. Retightenthelockscrewifnecessary.
6. InstalltheDomeCoverbyaligningthecaptivefastenerwiththematingthreadedinsertonthecamera
housing.Thecoverwillbeheldinplacebymagnets.
7. TightenthecaptivefastenertosecuretheDomeCoverinplace.CAUTION:Themagnetsaremeantto
holdtheDomeCoverinplaceduring
installation.Thecaptivefastener
mustbeusedtoproperlysecurethe
DomeCover.Failuretousethe
captivefastenermayresultinserious
injury.
8. TapDomeCoverwithfingerto
ensureproperinstallation.







Lenslockingscrewlocation
Tech
Tip
Tech
Tip