Installation manual

Corner Mount Adapter (AV-CRMA) Installation Instructions
(Sold Separately)
Inside the box:
A. Corner Mount Adapter
B. Pack of four (4) machine screws (#8-32
5/8”), twelve (12) screws, twelve (12)
anchors, and twelve (12) washers
Not included but needed:
 ¾” NPT Conduit
Image 22
1. Remove Corner Mount Adapter and
hardware from the box.
2. Attach provided Junction Box Adapter
(Image 1-B) to Corner Mount Adapter
as shown in Image 23.
3. Remove the conduit plug on Junction
box adapter and connect ¾” NPT
Conduit to Junction Box Adapter shown
in Image 23-1.
NOTE: Use silicon or water pipe seal tape
to make sure no water leakage between
conduit pipe and junction box adapter.
4. Run Ethernet Cable and other cables (if
necessary) through the Junction Box
Adapter and connect to Megaview® 2 pigtail
cable.
5. Attach MegaView
®
2 bracket to Corner
Mount Adapter as shown in Image 24.
6. Using the screws provided (or other
hardware) to attach the Corner Mount
Adapter to an exterior 90° corner wall.
7. To adjust MegaView
®
2 bracket, please
reference “Mounting the Camera”, if
needed.
Image 23 Image 23-1
Image 24
A
B
Wall
Mount
Adapter
p