Installation manual

Arecont Vision MegaView
®
2 Installation Manual
Page | 14 [e-mail]
Pole Mount Adapter (AV-PMA) Installation Instructions
(Sold Separately)
Inside the box:
A. Pole Mount Adapter
B. 2x Small Steel Straps
C. 2x Large Steel Straps
D. Pack of four (4) machine screws (#8-32
5/8”)
Not included but needed:
 ¾” NPT Conduit
Image 19
1. Remove Pole Mount Adapter, steel
Straps and hardware from the box.
2. Attach provided Junction Box Adapter
(Image 1-B) to Pole Mount Adapter as
shown in Image 20.
3. Remove the conduit plug on Junction
box adapter and connect ¾” NPT
Conduit to Junction Box Adapter shown
in Image 20-1.
NOTE: Use silicon or water pipe seal tape
to make sure no water leakage between
conduit pipe and junction box adapter.
4. Run Ethernet Cable and other cables (if
necessary) through the Junction Box
Adapter and connect to MegaView
®
2
pigtail cable.
5. Attach MegaView
®
2 bracket to Pole
Mount Adapter as shown in Image 21.
6. Use the supplied two Steel Straps to
attach the Pole Mount Adapter to the
pole and tighten the compression
screws as shown in Image 21.
7. To adjust MegaView
®
2 bracket, please
reference “Mounting the Camera”, if
needed.
Image 20 Image 20-1
Image 21
A
B
C
D