Installation Manual

Installation Manual
Page | 11 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaVideo® Flex
Connecting the Sensor, Main Unit and Optional IR
NOTE: When connecting a sensor unit to a main unit, make sure the sensor and main unit are from the
same box. The camera could be undiscoverable if you swap different sensor units on a main unit.
Ref #
Description
1
After mounting the main unit and camera sensor to the desired location, insert the USB end of
the supplied 5ft or 40ft cable, depending on your application, to the location on the main unit
that reads “CAMERA” (Ref #1).
2
Insert the Micro-USB side of the cable into the back of the camera.
NOTE: You will need to recycle power once the USB cable is installed on both the sensor unit
and the main unit.
3
Using the supplied zip ties, wrap any cable slack around the hook on the back of the camera
to reduce strain.
4
Up to two optional infrared illuminators (AV-IRF) can be attached to the main unit. Each IR
illuminator includes 6 pcs of 850nm LEDs, has a 49.2ft (15 meter) IR distance (max) and an
80° IR angle.
5
Reset button