Installation Manual

Installation Manual
Page | 8 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaVideo® Flex
b. Mounting Camera Via Metal Bracket: This method is recommended if you want to
minimize drilling holes into a surface. Follow the instructions in the table below:
Ref #
Description
1 / 2
The metal sheet bracket plate (#1) and the metal sheet bracket base (#2) should already be
attached. The bracket plate can be adjusted up or down with a Philips head screwdriver.
3
Attach one of the two camera fastening nuts along the front edge of the camera bubble.
4
Insert the camera module through the front of the hole until the fastening nut is flush with the
metal sheet bracket.
5
Insert the other camera fastener nut on the back of the camera and tighten clockwise until
securely in place. Use the supplied Hex L-key to lock the set screws on both fastening nuts in
place. Do not over torque the screws.
6 / 7
For Drywall/ Masonry application: Securely fasten the metal sheet bracket by first installing
2x of the #6-32 1” Drywall/ Masonry Mounting Anchors (#6), place the metal sheet bracket
opening over the Drywall Mounting Anchors and use a Philips head screwdriver and install 2x
of the #6-32 1” Wood/ Metal Sheet Screws (#7).
8
9
10