Installation Manual

Installation Manual
Page | 19 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MegaVideo® Flex
SD Card Tab
Menu
Feature
Description
Playback
Allows the user to choose the specific time of video to playback.
Click to Play
Button to play video specified in the Playback field.
Continuous Recording
Allows the user to continuously record without restriction.
Default is unchecked box.
Stop Continuous
Recording AND Enable
Event-triggered
Recording
Allows the user to enable events recording when network
failure, motion alarm, or an I/O alarm is triggered. Default is
unchecked box.
NOTE: if the continuous recording is disabled and no event
recording is enabled, the SD card will not initiate recording.
Network Failure
Allows the SD Card to record video only in the event that the
network fails.
Motion Alarm
Allows the SD Card to record video only in the event that motion
is detected.
I/O Alarm
Allows the SD Card to record video only in the event that an I/O
alarm is triggered.
Recording Framerate
Allows setting a frame rate output limit for the H.264 video
stream. Default value is “Max” minimum fps is 1. Reducing the
frame rate output is another way to control the bandwidth used
for the H.264 video streaming from the camera trade off is the
obvious reduction of frame rate output at the camera. Options
are 0 to 30. No default.
SD Card Image
Resolution
Provides the ability to set the resolution. Options are Full or
Half. Half is the default.
Start
Shows the beginning time frame of the video being recorded.
No default.
End
Shows the ending time frame of the video being recorded. No
default.
Delete All Records
Allows the user to delete any previously recorded video on the
SD card.