Installation Manual

Arecont Vision MegaBall™ Installation Manual
7 | Page
20. If adding dome cover (Image 1E) on the bezel
is necessary, follow Step 21-23 to replace
installed bezel with provided audio bezel
(Image 1C) and get best audio quality.
Audio Bezel Installation ( -DA models only):
21. Remove O-ring (Image 1D), screws and
rubber cable from default bezel as shown in
Image 15.
Image 15
22. Install screws and dome bubble on the audio
bezel as shown in Image 16.
Image 16
23. Secure the dome cover to the camera using
the provided Security L-Key (Image 1H) as
shown in Image 17.
Image 17
Note: If the dome cover is not required, keep using
default bezel and make sure the microphone hole is
not covered by the liner as shown on Image 18.
Image 18
O-ring
Rubber
Cable
Audio
Bezel
Microphone
hole
Default Bezel