Installation Manual

Installation Manual
Page | 38 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
SurroundVideo® Omni SX
Troubleshooting
Before troubleshooting, visit http://www.arecontvision.com/ to ensure your camera has the most current
firmware version.
Problem
Possible Cause
Solution
Reflection on
the image
• Lens faces the bubble’s
crease.
• The angle between the lens
and bubble are not
perpendicular.
• Ensure the lens faces the bubble
perpendicularly.
• Avoid facing the lens at the bubble’s
crease.
• Ensure each lens is tilted up 90º when
facing down as shown below.
Day/Night
switch failure or
image quality
problem
The lens motor positioned to close to
the board may cause interference.
Ensure each lens motor is positioned away from
the board.