Installation Manual

!! ! Installation!Manual!
Page | 8 [e-mail]
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MicroDome®!G2
NOTE: If you use the side connection of the NPT port, remove the cap covering the side entrance,
otherwise; leave the cap in place. If using the NPT port, always use Teflon tape around the threads to
ensure proper sealing.
5. Route the cable tree from the camera around the rear of the camera module and secure all
cables. See the Connections section for details on how to connect the camera.
6. Check that the indicator LED’s are illuminated to the desired conditions (see LED Indicator
table).
7. Adjust the pan and tilt to obtain the desired field of view. Then, lock the camera head in place by
tightening at least two of the three set-screws with the supplied flat-head screwdriver (Figure 5).
Do not over torque the screws.
!
Figure 5: Lock camera head after adjusting the field of view
NOTE: Ensure not to press the remote focus motor against the sides of the camera module when
adjusting the field of view (Figure 5).
Figure 5: Remote focus motor
8. Install the dome cover by aligning the captive fasteners on the camera housing. If installing
inside a 4S junction box, the MCD-4S accessory dome cover plate (sold separately) is required.
CAUTION! The captive fasteners must be used to properly secure the dome cover. Failure
to use the captive fastener may result in serious injury. When mounting the dome cover to
the camera housing, ensure that the gasket is properly seated and not folded. Failure to
do so may result in water and dust ingress.