Installation Manual

!! ! Installation!Manual!
Page | 6 [e-mail]
!
!
!
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
MicroDome®!G2
Surface Mount (-S Model) Installation
1. Determine a secure location to mount the camera.
2. Remove the dome cover from the camera by unscrewing the three captive fasteners.
Figure 1: Remove dome cover
3. If required, the lens may be further secured by tightening the three lens lock screws using the
supplied flat-head screwdriver. Do not over torque the screws.
Figure 2: Optional: further tighten three lens lock screws
4. The camera can be mounted two ways: surface mount or via a junction box to a wall or ceiling.
Choose the best method for your installation below:
a. Surface Mount: use the supplied template to mark three desired holes (there are six
holes to choose from; see Figure 3). Then drill the holes with a diameter of 8 mm (0.3 in)
and insert the supplied anchors into the holes. Attach the camera module and supplied
gasket securely using the supplied screws.