Installation manual

Arecont Vision MegaVideo
®
Compact Camera Series Installation Manual
5 | Page
MegaVideo
®
Compact Camera I/O Cable Connection
• Flathead screwdriver
Required Tools:
Image 14
1. To use the I/O ports of the MegaVideo
®
Compact Camera, insert the connector into the
camera and locate the “I/O” ports as shown in
Image 14. NOTE: There are six connectors
that look identical, be sure to use the correct
I/O ports as shown in Image 15.
Image 15
Electrical Characteristics: Min Max
Input voltage (V)
ON
2.9
6.3
(measured between + and –
terminals)
OFF 0 1.3
Output current (mA)
ON
-
50
(measured between + and – terminals)
Applied Voltage Rage: 0 - 80V
OFF - 0.1
Table 1
NOTE: Both the input and the output are electrically
isolated from the rest of the camera’s electrical
circuitry via general-purpose photo couplers. The
input is additionally protected with a serial 250 Ohm
resistor and a debouncing circuit. Duration of any
input signal should be at least 5ms to comply with
the requirements of the debouncing circuit.
Input
Output