Installation manual

Arecont Vision MegaVideo
®
Compact Camera Series Installation Manual
1 | Page
MegaVideo
®
Compact Camera Installation Manual
A. MegaVideo
Inside the box:
®
B. Rubber gasket (preinstall on the camera)
compact camera
C. CD with AV100 software and user
manuals (license key required for
recording)
D. C to CS lens adapter
E. 0.5mm lens spacer ring
F. 6-position external power & IO plug
G. 0.05” hex L-Key
Image 1
1. Remove the camera and hardware from the
box.
Camera Power Up:
2. Attach the camera to the mounting bracket.
3. Connect the MegaVideo
®
Compact Camera to
a PoE port on 100Mbps network PoE switch
using an Ethernet cable as shown in Image 2,
if using a PoE solution.
Image 2
4. Connect the PoE switch to your computer’s
network port using an Ethernet cable. If the
camera will be powered via PoE, please skip
to step 5.
NOTE: A yellow LED on the rear of the camera
will turn on after a few seconds.
a. The flashing yellow LED indicates that a
link to your computer has been
established.
b. A green LED will blink when the camera
has been accessed.
5. If the camera is powered by an outside power
supply, connect the power wires to the
appropriate contacts of the 6-postion
connector using a small flathead screwdriver
and connect the 6-position plug to the camera
as shown in Image 3-1.
F
E
C
A
D
B
G