Arecont Vision MegaVideo® Compact Camera Series Installation Manual 0|P a g e
Arecont Vision MegaVideo® Compact Camera Series Installation Manual ® MegaVideo Compact Camera Installation Manual Inside the box: ® MegaVideo compact camera Rubber gasket (preinstall on the camera) CD with AV100 software and user manuals (license key required for recording) D. C to CS lens adapter E. 0.5mm lens spacer ring F. 6-position external power & IO plug G. 0.05” hex L-Key A. B. C. Image 2 4. A B C Connect the PoE switch to your computer’s network port using an Ethernet cable.
Arecont Vision MegaVideo® Compact Camera Series Installation Manual NOTE 1: Ensure that the polarity of the DC input on the camera matches the way that wires are installed in the connector shown in Image 3-2. NOTE 2: AC power does not have polarity. Image 4 8. Image 5 Select “Run” next to “Setup Cameras” from the AV100 application manager as shown in Image 6 and wait for “Arecont Vision Camera Installer” window to appear as shown in Image 7. Image 3-1 9. Image 3-2 Camera Installation: 6. 7.
Arecont Vision MegaVideo® Compact Camera Series Installation Manual Image 8 13. When all cameras appear, select “Save/Exit.” The AV100 application manager will appear. Image 7 10. Select “Install Cameras” on the Arecont Vision Camera Installer as shown in Image 7. 11. Confirm all cameras connected to the network switch appear in the upper window. 12. Repeat Step 10 if all of the cameras do not appear in the upper window.
Arecont Vision MegaVideo® Compact Camera Series Installation Manual NOTE: The Ultra HD Lens series is C mount and will require the C/CS lens adapter ring in order to adjust the back focus as shown in Image 10. 16. Loosen the set screws on the lens. 17. Fully open the lens iris aperture. 18. Focus the camera lens (Skip Step 19-21 if correctly focused). 22. Close the lens aperture as necessary to obtain depth of field. 23. Tighten the set screws on the lens.
Arecont Vision MegaVideo® Compact Camera Series Installation Manual ® MegaVideo Compact Camera I/O Cable Connection Required Tools: • Flathead screwdriver Input Output Image 15 Image 14 1. ® To use the I/O ports of the MegaVideo Compact Camera, insert the connector into the camera and locate the “I/O” ports as shown in Image 14. NOTE: There are six connectors that look identical, be sure to use the correct I/O ports as shown in Image 15.
Arecont Vision MegaVideo® Compact Camera Series Installation Manual 6|P a g e
