Installation Manual

Page | 35 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
SD Card Set-up via Web Interface
To set-up the SD card via the web interface, open your preferred web browser and type the camera’s
IP address.
NOTE: For supporting H.264 streaming on a webpage, the recommended browsers are Internet
Explorer and Firefox.
Figure 1
Click SD Card tab under System Options:
Figure 2
Select one of the recording methods:
•
Continuous Recording to start continuously recording.
•
Stop Continuous Recording AND Enable Event-triggered Recording to enable
events recording
(
for network failure, motion alarm and/or I/O alarm trigger.
The Start and End times are visible once the camera starts recording as shown in Figure 3. The start
time represents the beginning time of the oldest recording.