Installation Manual

Installation Manual
Page | 32 support@arecontvision.com
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com avsales@arecontvision.com
SurroundVideo® Omni SX
Camera Power Up
This product should be installed by a qualified service technician in accordance with the
National Electrical Code (NEC 800 CEC Section 60) or applicable local code. Make sure
that your installation of wires complies with Electrical Code of the local government where
the camera is installed and no bare wires are exposed.
1. Connect the camera to a PoE port on 100Mbps network PoE switch using an Ethernet cable as
shown in the image below.
Reference #
Description
1
PoE Connector
2. If the camera is powered by an outside power supply, 18~48VDC or 24VAC, connect the power
cable.
Auxiliary Power
If the camera is powered by a separate outside AC or DC power source, run the supplied power cable
through the access hole on the camera housing and connect the power cable to the 4-position
connector on the main camera board. The approximate location of the 4-position connector is circled
below.