Installation Manual

Installation Manual
Page | 26 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
SurroundVideo® Omni SX
Adjusting the Pan, Tilt and Focus
1. Remove the dome cover by loosening the captive fasteners with the supplied Philips head
screwdriver.
2. Power on the camera to adjust the pan, tilt and focus.
3. Adjust the pan and tilt to obtain the desired field of view. Then, lock the camera head in place by
tightening at least two of the three set-screws with the supplied flat-head screwdriver (Figure 1).
Do not over torque the screws.
Figure 1: Lock camera head after adjusting the field of view
NOTE: Ensure not to press the remote focus motor against the sides of the camera module when
adjusting the field of view (Figure 2).
Figure 2: Remote focus motor
4. To adjust the focus, see the Remote Focus Section of this manual.