Installation Manual

Installation Manual
Page | 23 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
SurroundVideo® Omni SX
Setting up the Cameras
The SurroundVideo® Omni SX is user configurable. Prior to installing the camera, thought should be
given to the sensor positions. It is always easier to make adjustments before the camera is installed.
The camera lenses are shipped in a 360º position as shown below (Figure 2). To customize the
sensors, simply remove the two screws for each individual sensor, position anywhere on the magnetic
track and then screw into place. Screw holes around the circumference are spaced in 5 degree
increments. The arrows marked on the track plate are 45 degree reference points (Figure 1).
Sensor numbering is indicated on the track plate; which corresponds to the sensor number via the
camera software (Figure 1). The slots on the track plate provide additional adjustment of the camera
after installation. Simply loosen the three screws to rotate the plate then tighten the three screws after
alignment. This feature is most useful for repositioning the cameras mounted to the center locations
after the camera installation.
Figure 1: Arrows on the track plate indicate 45º increments
Figure 2: 360º configuration (ideal for hallways)
Each hole on
the track
represents a
5º increment.