Installation Manual

Installation Manual
Page | 26 [e-mail]
+1.818.937.0700 877.CAMERA.8 www.arecontvision.com [e-mail]
SurroundVideo
®
G5 Mini
Adjusting the Pan, Tilt and Focus
1. Remove the dome cover by loosening the captive fasteners with the supplied security L-key
screwdriver.
2. Power on the camera to adjust the pan, tilt and focus.
3. To adjust the gimbal tilt, use #2 Phillips screwdriver to loosen two Philips head screws on both
sides of the Gimbal, no more than two full turns. Adjust the pan and tilt to obtain the desired field
of view as shown in Figure 1. NOTE: Do not remove the screws!
180 configuration 360 Configuration
Figure 1: Loose camera head to adjust the field of view
4. To adjust each lens in the 360 configuration, loosen the two set screws on the top shell with a
#1 Phillips screwdriver. Adjust each lens angle tilt as required and tighten the two set screws
show in the image below.