Installation manual

Arecont Vision SurroundVideo
®
WDR Camera Installation Manual
18 | P a g e
AV12186DN / AV12366DN / MegaDome
®
I/O Cable Connection
Inside the box:
A. I/O Cable
Not included but needed:
 Flat head screw driver
Image 40
1. Run the I/O cable through the hole in the
bottom of the camera and plug it into the 4-pin
connector as shown in image 41. NOTE: The
connector requires certain insertion force.
Please, use a flat head screwdriver to push
receptacle in. Make sure not to damage wire
insulation.
Image 38
Table 1
Electrical Characteristics:
Min
Max
Input voltage (V)
ON
2.9
6.3
(measured between + and –
terminals)
OFF
0
1.3
Output current (mA)
ON
-
50
(measured between + and – terminals)
Applied Voltage Rage: 0 - 80V
OFF
-
0.1
NOTE: Both the input and the output are electrically
isolated from the rest of the camera’s
electrical circuitry via general-purpose photo
couplers. The input is additionally protected
with a serial 250 Ohm resistor, and a de-
bouncing circuit. Duration of any input signal
should be at least 5 ms to comply with the
requirements of the de-bouncing circuit.
Table 2
Orange
OUT +
Yellow
OUT –
White
IN +
Black
IN -
A