Installation manual

Arecont Vision SurroundVideo
®
WDR Camera Installation Manual
13 | P a g e
AV12186DN / AV12366DN / MegaDome
®
Flush Mount Adapter (MD-FMA) Installation Instructions
Inside the box:
A. Flush Mount Adapter
B. White Trim Ring
Pack of four (4) machine screws (#8-32
½”) and one (1) I-Blot
C. Mounting template
Not included but needed:
 #2 Phillips head screw driver
Image 26
1. Remove Flush Mount Adapter, Trim Ring and
hardware from the box
2. Attach Dome to Flush Mount Adapter as
shown in Image 27. Please reference
“Mounting the Camera”, if needed.
3. Using the Mounting template, cut a hole in
surface for mounting.
4. Insert Flush Mount Adapter into the hole.
5. Screw the “lever screws” until the FMA is
snuggly installed, as shown in Image 27. The
“Support Arm” will ride down the screw to
compress the mounting surface. NOTE: Do
not over-torque the lever screws
6. Attach the Trim Ring to the Flush Mount Adapter
by rotating clockwise as show in Image 28.
Image 27
Image 28
B
C
A
Lever
screw
D
Support
Arm