Installation manual

Arecont Vision SurroundVideo
®
WDR Camera Installation Manual
AV12186DN / AV12366DN / MegaDome
®
Wall Mount (MD-WMT2) Installation Instructions
Inside the box:
A. Wall mount
B. Top shield
C. Mounting template
D. One double sided hex key
E. Pack of four (4) machine screws (#8-32
½”)
F. Pack of four (4) screws and four (4)
anchors
NOTE: Anchors and screws are good to be used for
concrete, wall block and red bricks. Screws by
themselves can be used in wood.
Not included but needed:
 #2 Phillips head screw driver
Image 20
1. Remove Wall Mount and hardware from the
box.
Image 21
2. Using the mounting template, prepare the
mounting surface.
3. Install Top Shield on Wall Mount as shown in
image 21.
4. Fasten the socket set screw using double side
hex key.
5. Run Ethernet Cable and outside power cable
(if necessary) through the Wall Mount.
6. Attach Wall Mount to the wall using drywall
screws or any optional hardware suitable for
the mounting surface.
7. For installation of the camera, please
reference “Mounting the Camera”.
B
E
D
C
A
F