User manual

BIOS CONFIGURATION

ure the DHCP function of the controller, move the cursor bar to

“DHCP Function” item, then press Enter key to show the DHCP

setting. Select the “Disabled’ or ‘Enabled” option to enable or

disable the DHCP function. If DHCP is disabled, it will be neces-

sary to manually enter a static IP address that does not conict

with other devices on the network.

3.7.6.2 Local IP address

If you intend to set up your client computers manually (no

DHCP), make sure that the assigned IP address is in the same

range as the default router address and that it is unique to your

private network. However, it is highly recommend to use DHCP

if that option is available on your network. An IP address alloca-

tion scheme will reduce the time it takes to set-up client com-

puters and eliminate the possibilities of administrative errors

and duplicate addresses. To manually congure the local IP ad-

dress of the controller, move the cursor bar to “Local IP address”

item, then press the Enter key to show the default address set-

ting in the SATA RAID controller. You can then reassign the static

IP address of the controller.

Controller I/O Port:F3000000h, F2: Select Controller, F10: Reboot System

ArrowKey Or AZ:Move Cursor, Enter: Select, ESC: Escape, L:Line Draw, X: Redraw

Areca Technology Corporation RAID Controller

Main Menu

Quick Volume/Raid Setup

Raid Set Function

Volume Set Function

Physical Drives

Raid System Function

Ethernet Conguration

View System Events

Clear Event Buffer

Hardware Monitor

System Information

Ethernet Conguration

DHCP Function : Enable

Local IP Address : 192.168.001.100

Ethernet Address : 00.04.D9.7F.FF.FF

Local IP Address : 192.168.001.100

Edit The local IP Address

92.168.001.100