User manual

HARDWARE INSTALLATION

Warning:

High voltages may be found inside computer equipment. Be-

fore installing any of the hardware in this package or remov-

ing the protective covers of any computer equipment, turn

off power switches and disconnect power cords. Do not re-

connect the power cords until you have replaced the covers.

2.3 Installation

Follow the instructions below to install a SATA RAID controller into

your PC / Server.

Step 1. Unpack

Unpack and remove the SATA RAID controller from the package.

Inspect it carefully, if anything is missing or damaged, contact your

local dealer.

Step 2. Power PC/Server Off

Turn off computer and remove the AC power cord. Remove the

system’s cover. See the computer system documentation for in-

struction.

Electrostatic Discharge

Static electricity can cause serious damage to the electronic com-

ponents on this SATA RAID controller. To avoid damage caused by

electrostatic discharge, observe the following precautions:

• Do not remove the SATA RAID controller from its anti-static

packaging until you are ready to install it into a computer case.

• Handle the SATA RAID Controller by its edges or by the metal

mounting brackets at its each end.

• Before you handle the SATA RAID controller in any way, touch a

grounded, anti-static surface, such as an unpainted portion of the

system chassis, for a few seconds to discharge any built-up static

electricity.