User manual

DRIVER INSTALLATION

4. Press F6 when the screen shows ”Setup is inspecting your

Computer’s hardware Conﬁguration”. This must be done or

else the new driver installed from the SATA RAID driver diskette

will not be recognized.

5. The next screen will show: “Setup could not determine the

type of one or more mass storage device installed in your

system.” Selected specify additional SCSI adapter by pressing

6. Window will prompt for the “Manufacturer-supplied hard-

ware support disk” into ﬂoppy drive A: Insert the SATA RAID

series driver diskette in drive “A:” and press Enter.

7. Window will check the ﬂoppy and select the correct drive and

CPU type in the listing that you want to install and press Enter

to install it.

8. After Windows scans the hardware and ﬁnds the controller, it

will display:

“Setup will load support for the following Mass Storage

devices:”

“Windows 2K, XP,2K3 (ARC1XX0) SATA PCI-X (or PCI-Ex-

press) RAID Controller”. Press Enter to continue and copy

the driver ﬁles.

At this point, simply follow the Microsoft Windows installation

procedure.

Follow the on-screen instructions, responding as needed to com-

plete the installation.

9. After the installation is completed, reboot the system to load

the new drivers.

10. See Chapter 5 in this manual to customize your RAID vol-

ume sets using Storage manager.

4.2.2.2 Making Volume Sets Available to Windows

System

When you reboot the system, log in as system administrator.

Continue with the following steps to make any new volume sets