Installation Guide

8
I
nstallation Optio
n:
Product return:
Please refer installation instruction to remove lock from door, remove levers
from lock, and then refer the following diagram to pack lock.
fig. 12 fig. 13
The lock will stay on vertical position on the door as long as
the two mounting screws were tied up in most case. You may
put a tapping screw on inside chassis to increase lock stability.
1. Remove two screws in battery compartment. You will see
mounting hole under battery compartment.
2. Use 3/8" (8 mm) Drill Bits to drill a hole on door through
mounting hole.
3. Put screw pole on front metal plate.
4.
Put screw through mounting hole to connect with screw
pole.
5. Put battery compartment back.