Installation Guide

Keypad blue light will stay on after unlock and turn off when locked. Red light indicates that system reject or input error. Blue light flash indicates that system is waiting user input. Press to log out system during blue light flash when finish operation or want to start over if make a mistake. You may input any number before or after user code when unlock by code.
Ardwolf A1 Quick Programming Guide
fig. 12 fig. 13
Product return:
Please refer installation instruction to remove lock
from door, remove levers from lock, and then refer
the following diagram to pack lock.
Installation Option:
The lock will stay on vertical position on the door as long as the
two mounting screws were tied up in most case. You may put a
tapping screw on inside chassis to increase lock stability.
1. Remove two screws in battery compartment. You will see
mounting hole under battery compartment.
2. Use 1/8" (3 mm) Drill Bits to drill a hole on door. through
mounting hole.
3. Screw tapping screw in.
4. Put battery compartment back.
Customer Service:
Call: [phone]
E-mail: [e-mail]
www.ardwolf.com