Datasheet

PROTO SHIEL D REV3 ( UNO SIZE)

Code: TSX00083

Make your projects rock solid with the Prototyping Shield.

It makes it easy for you to design custom circuits and solder electronics directly

on it.

The ProtoShield makes it easy for you to design custom circuits. You can easily solder TH or SMD ICs on

the prototyping area to test them with your Arduino board. The SMD area is designed for a maximum of 24

pins SOIC integrated circuit and the TH area contains a lot of space for the needed components around your

project. You can even stick a mini breadboard (not included) on the protoarea for solderless operation. The

proto area includes also two power lines (IOREF and GND), two LEDs pads and SPI signals breakout pads

for boards with SPI only on the ICSP header like Zero.

Key features:

 1.0 Arduino Pinout

 1 ICSP Connector footprint

 2 LEDs and resistor footprint

 IOREF and GND power lines

 SPI signals pads

 24 pin SMD footprint (50 mils pitch)

PAGE 1
P R O TO S H I E L D R E V 3 ( U N O S I Z E ) Code: TSX00083 Make your projects rock solid with the Prototyping Shield. It makes it easy for you to design custom circuits and solder electronics directly on it. The ProtoShield makes it easy for you to design custom circuits. You can easily solder TH or SMD ICs on the prototyping area to test them with your Arduino board.
PAGE 2
OSH: Schematics Arduino Proto Shield is open-source hardware! You can build your own board using the following files: EAGLE FILES IN .ZIPSCHEMATICS IN .PDF Power The Proto Shield bring the power from the Arduino standard IOREF and GND pins to the two power bus rows placed between the Through Hole prototyping are, which can be used for powering correctly your project independently on the chosen board (3V3 or 5V).
PAGE 3