IoT Prime Bundle with MKR1010 Code: AKX00018 The MKR IoT Prime Bundle with MKR WIFI 1010 walks you through the basics of using the Arduino MKR1010 for IoT applications, in conjunction of MKR Environmental Shield and MKR Relay carrier and Arduino Cloud.
Each bundle includes: 1 Arduino MKR WIFI 1010 board 1 Arduino MKR ENV shield 1 MKR relay proto shield 1 Breadboard 1 LED (Red) 1 LED (Green) 1 LED (Yellow) 1 LED (Blue) 1 LED (RGB) 1 Piezo Capsule 70 Solid Core Jumper Wires 1 Photoresistor 20 Resistors 22 Ohm 5 Resistors 56 Ohm 5 Resistors 1K Ohm 20 Resistors 10K Ohm 5 Resistors 1M Ohm 5 Resistors 10M Ohm 1 USB cable
Want to add a WiFi interface to your devices? Get the MKR WIFI 1010 The MKR WIFI 1010 is a significant improvement on the MKR 1000 WIFI. It's equipped with an ESP32 module made by U-BLOX. This board aims to speed up and simplify the prototyping of WiFi based IoT applications thanks to the flexibility of the ESP32 module and its low power consumption. The board is composed of three main blocks: • SAMD21 Cortex-M0+ 32bit Low Power ARM MCU • U-BLOX NINA-W10 Series Low Power 2.4GHz IEEE® 802.
It has a Li-Po charging circuit that allows the Arduino MKR WIFI 1010 to run on battery power or an external 5 volt source, charging the Li-Po battery while running on external power. Switching from one source to the other is done automatically. Warning: Unlike most Arduino boards, the MKR WIFI 1010 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board.
ARDUINO MKR ENV SHIELD Add environmental sensors to your MKR board at a glance. The MKR ENV Shield allows a MKR board to acquire environmental data collected by an array of sensors.
To help you build projects and store the data collected locally, this shield has a slot for a microSD card (not provided). There is a ready to use library with examples and methods to read values from the different sensors, that provides an easy and smooth integration path. Sensors used : ST LPS22HB : atmospheric pressure ST HTS221 : temperature and humidity VISHAY TEMT6000 : Lux of the ambient.
ICs Input Voltage Operating Voltage Ranges Communicatio n Length Width Weight LPS22HB TEMT6000 VEML6075 3.3V 3.3V Pressure: 260 to 1260 hPa rH sensitivity: 0.004% rH/LSB Humidity accuracy: ± 3.5% rH, 20 to +80% rH UVA, UVB and UVBI measurment I2C/Analog 61 mm 25 mm 32 gr.
ARDUINO MKR RELAY SHIELD The MKR Relay Proto Shield allows you to easily command relays with your MKR board. The shield provides two on board relays and a small prototyping area if you need to add some other component to your project. The MKR Relay Shield allows you to easily add relays to your MKR board based project. The shield provides two relays called RELAY1 and RELAY2 commanded by pin 1 and pin 2 respectively.
The IoT Prime Bundle with MKR WIFI 1010 is based on the Arduino's unique 'Panini Concept' — where designers pick up a MKR board, then mix-and-match it with the desired shields and carrier boards to create custom hardware configurations for IoT projects as if they were crafting a sandwich!
