Datasheet

For further info, visit:
STORE. ARDUINO. CC/ ARDUINO- PRO- GATEWAY
ASSEMBLY AND
SETUP INSTRUCTIONS:
1 . Insert the SD card then attach the fan as shown in
the picture then screw together the enclosure panel
with the SMA pigtail. 2. Wire the Fan cables with the
clips as shown in the image above.
3. Connect the SMA pigtail to the X1 antenna
connector. 4. Insert the boards into the enclosure -
Important: make sure to take note of the code from
the sticker on the radio module, before placing it
inside the enclosure (you’ll need it later).
5. Connect the antenna. 6. Plug-in the power supply
and the Ethernet Cable.
Follow the instructions and enter the code you noted
in the 4. You’re all set! Welcome to the LoRa® world!
7. Visit: CREATE.ARDUINO.CC/GETTINGSTARTED/LORAGW
5
6
1
2
3 4
KIT BOX INCLUDES
1 Aluminium Enclosure
1 Raspberry Pi 3 model B+
1 Arduino Radio Module Adapter
1 LoRa® Radio module
1 Fan
1 Ethernet cable
1 AC power adapter (with multi plug)
1 Micro UFL to SMA Pigtail
1 SMA Antenna
1 MicroSD card
TECH SPECS
•AUTOMATED METER READING
•ENVIRONMENTAL MONITOR
•SMART CITIES
•HOME AND BUILDING AUTOMATION
•WIRELESS ALARM AND SECURITY SYSTEM
•INDUSTRIAL MONITORING AND CONTROL
•LONG RANGE IRRIGATION SYSTEM
•AGRICULTURAL MONITORING
•LORA GATEWAY CAPE ADAPTER
•CHIPSET
•OPERATING VOLTAGE
•CURRENT CONSUMPTION
•MODULATION
•OPERATING FREQUENCY
•OPERATING TEMPERATURE
•RF OUTPUT POWER
•SENSITIVITY
FEATURES:
•LISTEN BEFORE TALK (LBT) CAPABILITY
•ON-BOARD UFL ANTENNA
•8 LORA CHANNELS
•FPGA SUPPORTS LORA SPECTRAL SCAN
SEMTECH SX1301 WITH TWO SX1257
5V
815MA (TX@+27DBM); 600MA (RX)
LORA® SPREAD SPECTRUM, FSK, GFSK
868MHZ (EU)
-40°C TO +85°C
UP TO +27DBM
UP TO -137DBM
WHAT’S IN YOUR
ARDUINO PRO GATEWAY?
Raspberry Pi
3 model B+
Arduino Radio
Module Adapter
LoRa® Radio
Module