Datasheet

ManualsBrandsArduino ManualsArduinoArduino Nano 33 BLE

31/5/2019 https://store.arduino.cc/usa/datasheet/index/index/url_key/nano-33-ble-reseller/

https://store.arduino.cc/usa/datasheet/index/index/url_key/nano-33-ble-reseller/ 1/3

Arduino Nano 33 BLE

Designed for short range BT interactions and power savvy projects.

SKU: ABX00030

Country of origin: IT

Taric: 85235210

EECN: 5A992.c

HTS: 8542310001

Overview

This compact and reliable NANO board is built around the NINA B306 module, based on Nordic nRF 52840 and containing a powerful Cortex M4F.

Its architecture, fully compatible with Arduino IDE Online and Offline, has a 9 axis Inertial Measurement Unit (IMU) and a reduced power consumption

compared to

other same size boards.

This allows the design of

wearable devices and movement sensing projects that need to communicate to other devices at a close range. Arduino NANO 33 BLE is

also ideal for automation projects thanks to the multiprotocol BT 5.0 radio.

Tech Specs

This board is based on the nRF 52840 microcontroller.

Clock 64MHz

Flash 1MB

RAM 256KB

Please note: Arduino Nano 33 BLE only supports 3.3V I/Os and is NOT 5V tolerant so please make sure you are not directly connecting 5V signals to this board or

it will be damaged. Also, as opposed to Arduino Nano boards that support 5V operation, the 5V pin does NOT supply voltage but is rather connected, through a

jumper, to the USB power input.

The Bluetooth is managed by a

NINA B306 module.

Summary of content (3 pages)

PAGE 1
31/5/2019 https://store.arduino.cc/usa/datasheet/index/index/url_key/nano-33-ble-reseller/ Arduino Nano 33 BLE Designed for short range BT interactions and power savvy projects. SKU: ABX00030 Country of origin: IT Taric: 85235210 EECN: 5A992.c HTS: 8542310001 Overview This compact and reliable NANO board is built around the NINA B306 module, based on Nordic nRF 52840 and containing a powerful Cortex M4F.
PAGE 2
31/5/2019 https://store.arduino.cc/usa/datasheet/index/index/url_key/nano-33-ble-reseller/ The IMU is a LSM9DS1 and it is managed through I2C. The board has a two 15 pins connectors - one on each side -, pin to pin compatible with the original Arduino Nano.
PAGE 3
1/5/2019 https://store.arduino.cc/usa/datasheet/index/index/url_key/nano-33-ble-reseller/ (*) As opposed to other Arduino Nano boards, pins A4 and A5 have an internal pull up and default to be used as an I2C Bus so usage as analog inputs is not recommended. posed to Arduino Nano boards that support 5V operation, the 5V pin does NOT supply voltage but is rather connected, through a jumper, to the USB power input.