Datasheet

The Arduino MKR WAN 1310 board provides a practical and cost

effective solution to add LoRa® connectivity to projects requiring

low power. This open source board can be connected to: Arduino

Create, to your own LoRa® network using the Arduino Pro

Gateway for LoRa®, to existing LoRaWAN™ infrastructure like

The Things Network, or even to other boards using the direct

connectivity mode.

The MKR WAN 1310, brings in a series of improvements when

compared to its predecessor, the MKR WAN 1300. While still

based on the Atmel SAMD21 low power processor, the

Murata CMWX1ZZABZ LoRa® module, and the MKR family’s

characteristic crypto chip (the ECC508), the MKR WAN 1310

includes a new battery charger, a 2MByte SPI Flash, and

improved control of the board’s power consumption.

PAGE 1
The Arduino MKR WAN 1310 board provides a practical and cost effective solution to add LoRa® connectivity to projects requiring low power. This open source board can be connected to: Arduino Create, to your own LoRa® network using the Arduino Pro Gateway for LoRa®, to existing LoRaWAN™ infrastructure like The Things Network, or even to other boards using the direct connectivity mode. The MKR WAN 1310, brings in a series of improvements when compared to its predecessor, the MKR WAN 1300.
PAGE 2
The latest low power architecture has considerably improved the battery life on the MKR WAN 1310. When properly configured, the power consumption is now as low as 104uA! It is also possible to use the USB port to supply power (5V) to the board; run the board with or without batteries - the choice is yours. Data logging and other OTA (Over The Air) functions are now possible since the inclusion of the on board 2MByte Flash.