Datasheet

5V: This pin outputs 5V from the the board when powered from the USB connector or from the VIN pin of
the board. It is unregulated and the voltage is taken directly from the inputs.
VCC: This pin outputs 3.3V through the on-board voltage regulator. This voltage is 3.3V if USB or VIN is
used and equal to the series of the two batteries when they are used
LED ON: This LED is connected to the 5V input from either USB or VIN. It is not connected to the battery
power. This means that it lits up when power is from USB or VIN, but stays off when the board is running
on battery power. This maximizes the usage of the energy stored in the battery. It is therefore normal to
have the board properly running on battery power without the LED ON being lit.
Onboard LED: On MKR WAN 1300 the onboard LED is connected to D6 and not D13 as on the other
boards. Blink example or other sketcthes that uses pin 13 for on board LED may need to be changed to
work properly.