Datasheet
Table Of Contents
- applications
- features
- key specifications
- table of contents
- list of figures
- list of tables
- 1 signal descriptions
- 2 system level description
- 3 block level description
- 4 image sensor core digital functions
- 4.1 mirror and flip
- 4.2 image windowing
- 4.3 test pattern
- 4.4 50/60Hz detection
- 4.5 AEC and AGC algorithms
- 4.6 AEC/AGC steps
- 4.7 black level calibration (BLC)
- 4.8 strobe flash and frame exposure
- 4.9 xenon flash control
- 4.10 frame exposure (FREX) mode
- 4.11 FREX strobe flash control
- 4.12 one-time programmable (OTP) memory
- 5 image sensor processor digital functions
- 6 image sensor output interface digital functions
- 7 register tables
- table 7-1 system control registers (sheet 1 of 5)
- table 7-2 SCCB registers (sheet 1 of 2)
- table 7-3 group hold control registers
- table 7-4 AEC/AGC 1 registers
- table 7-5 system timing registers (sheet 1 of 3)
- table 7-6 AEC/AGC 2 registers (sheet 1 of 3)
- table 7-7 STROBE/frame exposure control registers (sheet 1 of 2)
- table 7-8 50/60 HZ DETECTION registers
- table 7-9 OTP control registers (sheet 1 of 2)
- table 7-10 BLC registers (sheet 1 of 3)
- table 7-11 frame control registers
- table 7-12 DVP registers (sheet 1 of 2)
- table 7-13 MIPI top registers (sheet 1 of 11)
- table 7-14 ISPFC registers
- table 7-15 ISP TOP control registers (sheet 1 of 6)
- table 7-16 AWB registers (sheet 1 of 3)
- table 7-17 average registers (sheet 1 of 2)
- table 7-18 DPC registers
- table 7-19 LENC registers (sheet 1 of 4)
- table 7-20 cluster DPC registers (sheet 1 of 2)
- table 7-21 windows registers
- table 7-22 AEC/AGC 3 registers
- 8 operating specifications
- 9 mechanical specifications
- 10 optical specifications
- revision history
Confidential for truly Only
11.03.2009 PRELIMINARY SPECIFICATION proprietary to OmniVision Technologies
4-15
4.9.1 LED1 & 2 mode
Two frames after the strobe request is submitted, the third frame is correctly exposed. The strobe pulse will be activated
only one time if the strobe end request is set correctly (see
figure 4-10). If end request is not sent, the strobe signal is
activated intermittently until the strobe end request is set (see figure 4-11). The number of skipped frames is
programmable using registers {0x3A1C, 0x3A1D}.
figure 4-10 LED 1 & 2 mode - one pulse output
vertical
blanking
exposure
time
data
out
strobe
request
strobe
pulse
correctly
exposed
frame
the number of skipped frames
is programmable
request here
start end
frame in is skipped
5647_DS_4_10