Quick Start Guide

2. Must TURN OFF the POWER to the light circuit at the circuit breaker to avoid the
electrical shock.
3. On the 2 gang Lighting Switch (“LS”) which you want to control, you will find 4 wiring
inputs for two loops. The first loop contains L1 and its COM (“L1-paired COM”) wiring
input. The second loop contains L2 and its COM (“L2-paired COM”) wiring input.
4. To connect L1 of LS to S
1
wiring input of Flora.And to connect L1-paired COM of LS to
S
A1
wiring input of Flora.
To connect L2 of LS to S
2
wiring input of Flora.And to connect L2-paired COM of LS to
S
A2
wiring input of Flora
5. Lights will have their own COM and N wiring. For the 1st loop, please find Light COM
and connect light COM to L1 of Flora, For the 2nd loop, please connect its light COM to
L2 of Flora.
6. Connect Power circuit to L of Flora
7. Connect N of lights, N of Power circuit, and N of Flora, the installation is finished.
8. The LED of Flora will start blinking while power on.
9. While joining Flora into the Zigbee networks, pressing Permit Join button in GUI to
proceed the pairing process. The LED on Flora will display green light after the pairing is
complete.
Safety Instructions
● Read,keep,and follow these instructions.
● Do not use this product near water or expose the product to dripping or splashing of any
water or liquid.
● Clean only with a dry cloth.
● Do not install near any heat sources such as radiators,heat registers,stoves or other
apparatus.
● All works on the device may be performed only by a qualified and licensed electrician.
● Configuration of connections or the load must be always performed with disconnected
voltage.
● Improper assembly may be dangerous.Carefully follow the assembly instructions.