Instruction Manual

EN
18
INSTALLATION (BEFORE USE)
• Please read the instruction carefully.
• Remove all the package.
• Do not connect the device to the outlet until you have completed the
installation.
• Familiarize yourself with the assembly picture, see Fig. 1.
• Install the telescopic pole in the corresponding hole on the device
body, see Fig. 2.
• After installing the pole turn it clockwise and make sure that the pole
is rmly tightened, see Fig. 3.
• Release the telescopic clamps, pull the aluminum rod up, see Fig. 4.
• Fix the chosen height of the pole using fasteners, see Fig. 5.
• Install the steam hose in the corresponding hole, see Fig. 6.
• Fix the handle of the steamer on the telescopic stand, see Fig. 7.
STEAMING INSTRUCTIONS
• Open the lid of the water tank and pour water, see Fig. 8 and Fig. 9.
• Do not pour hot water.
• Close the lid of the water tank, install the tank on the appliance body,
see Fig. 10 and Fig. 11.
• Pull out the power cable, connect it to the outlet, press the power
switch, see Fig. 12 and Fig. 13.
• After about one minute, the steam indicator will light up.
• Remove the steam brush from the pole and start steaming, gently
moving the brush up and down along the fabric, see Fig. 14.
• The steam tube may make gurgling sounds during operation. This is a
normal phenomenon. If such a sound occurs, hang the steam pipe on
a pole so that the condensate drains downwards.
• To prolong the service life of the appliance, after use pour the water
from the tank, turn on the appliance for 1 minute to dry the system
from residual water. After that, turn o the power and disconnect the
device from the outlet.