manual

We do the utmost to ensure that the provided informaon is complete and accurate; however, images and
specicaons are subject to change without noce. Visit our website at www.ardaappliances.com
for the latest version of this manual.
- 7 -
7. Mount the hood on the mounng screws. When the hood has been leveled, secure unit by
ghtening screws.



8. Connect a 6” aluminum duct tube (not included) between your hood and duct path. Ensure that
the damper aps are free to open. Seal all seams using duct tape.


1. Carefully loosen but do not separate the
telescopic chimney duct pieces (A & B - Fig. 10). The
inside piece is the top and aaches to the wall at the
ceiling. The outside piece is the boom and rests on
the range hood.
2. Plug in the hood.
3. Install the recirculaon kit if required.
4. Aach the wall bracket.


: adjust the
width of the support bracket (D) to match the
upper duct width. Fix it to the wall using the
screws. Mark a line 4 mm down from the ceiling.
Fix the adaptor to the wall using the screws
provided so that it is centered in line with your hood and at a distance from the ceiling indicated.
: on the wall, at the ceiling edge, center the bracket on the plumb line.
Aach to the wall using screws appropriate to the wall material.
5. Place the two nested chimney pieces on top of the range hood. Draw the inside/top piece up to
the ceiling and ax to the wall bracket using the provided screws.
6. Remove the decorave plasc wrap from the hood.
A
B
D
C
C
A. Upper vent cover
B. Lower vent cover
C. Screws
D. Bracket
Arda
Fig.10
A. Upper vent cover
B. Lower vent cover
C. Screws
D. Bracket
