User's Manual

21 of 47
Country Code Setting
If your mesh has radios which require a country code setting, and the country code has not yet
been set, the Set Country Code message will appear.
The Country Code settings allow operation at the maximum legal limit for that country; if it is not
set, the transmitters operate at very low power and range is limited. Until the Country code is set,
the default radio mode is 5.8 GHz DSSS, and the default radio channel is 161.
1. Make sure all radios are visible on the mesh.
2. Select the proper Country Code from the drop down list. Note that some countries have
several codes from which to choose.
3. Click the Set Country Code Now button to set the Country Code for all of the mesh radios. If
you click Set Later, the ‘‘Set Country Code’’ message will reappear later and the mesh will
continue to operate with severe limitations until a Country Code is set.