User's Manual

3.6.2 Local Utility Powered
Other powering is possible, using external converters from whatever the local utility
provides, into DC, 8-24 Vdc. This is connected to the Access Point power
connector.
In this application, the cable system tap passes only RF.
3.7 Pipe Mount Installation
The Access Point Mast Mount Kit is designed to mount the AP on a pipe.
The pipe size should be between 1.5 and 2.25 inches, outside diameter (OD).
The cable goes out the bottom of the Access Point.
The pipe can be mounted on a building roof, side of a building, side of a tower, or on
a utility pole.
Figure 3-5 shows the weather cover as a rear view of the Access Point on a pipe.
Rear weather cover
Figure 3-5: Access Point mounted on pipe.
Figure 3-6 shows the pipe mounting kit pieces. There are two such bracket pairs in
the Mounting Kit.
ARCXtend manual, August 2003 3-11