User's Manual

Figure 2-4: AR100 Signal Strength Meter (SSM).
Rx SSM LNB
Cable to modem
Temporary cable
Figure 2-5: AR100 Signal Strength Meter (SSM) at transceiver.
Connect the coax cable from the indoor power inserter to the SSM "Rx" port and a
temporary short coax jumper from the SSM "LNB" port to the Transceiver. The SSM
and the Transceiver will then be powered from the power inserter
3
.
Align the Transceiver by peaking the signal on the SSM's meter, adjusting the
sensitivity control on the SSM as needed.
Note that the AR100 SSM is a very broadband device that responds to energy below
500 MHz. It will “see” all energy from few hundred MHz to at least 1900 MHz, and
3
The external power jack on the SSM is unused.
ARCXtend manual, August 2003 2-4