User Manual

Installation Guide
3 of 27
Notices
The information in this publication is subject to change without notice. Arcwave shall not
be liable for technical or editorial errors or omissions nor for any damages resulting from
the use of this material.
U.S. Federal Communication Commission (FCC) Notification
This device complies with part 15 of the U. S. FCC Rules and Regulations and which is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the U.S. FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio-frequency energy and, if not installed
and used in accordance with these instructions, may cause harmful interference to radio
communications. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user is
encouraged to correct the interference by one or more of the following measures:
Increase the separation between the affected equipment and the unit;
• Connect the affected equipment to a power outlet on a different circuit from that
which the receiver is connected to;
• Consult the dealer and/or experienced radio/TV technician for help.
Part 15, Section 15.21 Warning
Changes or modifications not expressly approved by Arcwave, Inc. could void the user's
authority to operate the equipment. FCC IDs Numbers are listed below:
FCC Identifier: Pending
RF Safety Warning
To ensure compliance with FCC recommended General Population/Uncontrolled
exposure limits the ARCXtend Hub and CPE must be installed at a minimum of one foot
from areas frequented by the general population.