User Manual

Installation Guide
16 of 27
 Verify via the hub that hub has power and the embedded cable modem has
achieved operational status.
Provisioning the Link
Link provisioning is accomplished using via the ARCSmart HTTP web browser interface
or via the ARCNet element management system. The parameter names and assignments
are the same for both interfaces. Detailed information is available for both tools in their
respective user and installation guides located on the Arcwave Support Extranet,
http://www.arcwaveinc.com/support.html. This section describes the ARCSmart GUI and
shows how to perform a typical configuration.
To launch ARCSmart:
• Connect a computer to the hub’s RJ-45 Ethernet port.
• Open your Internet browser. You must use Microsoft Internet Explorer version
5.x or later.
• Enter the default IP address of the Hub (192.168.100.1) into the address bar of
your browser and press the enter key on your keyboard. An Enter Network
Password window appears.
• Enter the case sensitive username admin and press the Tab key to advance to the
password field.
• Enter the case sensitive password arcwave and press Enter.
Note the username and password can be changed using the Maintenance screen
• Click on Arcwave MIB in the left menu bar. This will launch the Hub
configuration screen shown below.
• Enter the configuration settings determined in the wireless link planning process: